User instructions
23
Do not use table salt as it contains insoluble substances which, over
time, may damage the water softening system.
When necessary, refill the regenerating salt container before
starting the washing program. In this way, the excess saline
solution will be immediately removed by the water; the prolonged
presence of salt water inside the tank may lead to corrosion.
Be careful not to confuse the salt and detergent packages; adding
detergent to the salt container will damage the water softening system.
ADJUSTING THE SOFTENER (only is fitted)
(available for all programs except the soak program)
The dishwasher is equipped with an electronic control system which
allows the softener setting to be varied to suit the hardness of the water.
To set the softener, proceed as follows.
Keep the
PROGRAM DELAY
button
pressed for a few seconds,
until the
h.-
symbol, followed by the set value, appears on the
DISPLAY.
Press the
PROGRAM DELAY
button again to select the most
suitable hardness value (
h.-0
,
h.-1
,
h.-2
…..
h.-6
). Refer to the "Water
hardness table" to select the value.
To exit the programming mode press any button or do not touch the
keypad for about
2 seconds
.
