Smeg DWA147, Инструкция по эксплуатации

Страница: 36 / 37

User instructions
34
6. Troubleshooting
The dishwasher is equipped with a self-diagnostics system that is capable of
detecting and signalling a number of possible faults
TABLE OF FAULTS DETECTED BY THE SELF-DIAGNOSTICS SYSTEM
FAULT DESCRIPTION
Er 01
The anti-flooding system (where present) has been tripped.
Er 02
The water level limitation system has tripped.
Er 03
The appliance cannot heat the water.
Er 04
The temperature sensor is disconnected.
Er 05
The appliance cannot take in the water.
Er 06
The appliance cannot drain the water from the tank.
Er 07
The dishwasher cannot measure the precise water quantity that has
been loaded.
Er 08
Problem on the water distribution system to the baskets.
Er 09
Water intake system malfunction
If an alarm occurs the appliance interrupts the program in progress and
signals a fault.
•
Alarms E1, E2, E3, E4, E8 and E9 interrupt the current program
immediately.
•
The E5 , E6 alarms interrupts the running program once the cause is
resolved, it will bring bach the execution of the program.
•
The alarm E7 is visualized at the end of the cycle that comes, however,
brought to the end since the operation of the dishwasher is not harmed.
To “reset” an alarm is necessary:
•
Open and close the door, or turn off and on the machine. At this point is
possible to program the dishwasher again.
If the malfunction persists, contact your authorised Service Centre.