Smeg CW520, Руководство пользователя

Страница: 33 / 37

‐ CW 520/530
33
12
TROUBLESHOOTING
If the system fails to pump out because the drain pump is
fouled (as a result of incorrect filter positioning), proceed as
follows:
Bale out the dishwasher with a basin and disconnect it from
the electrical mains.
Unscrew the screw A , release the tang B and lift it.
Check that the impeller of the drain pump underneath the
cover turns freely, and is free from dirt, limescale residues, or
pieces of glass. Never use tools, screwdrivers, scissors, etc.
PROBLEM POSSIBLE CAUSE POSSIBLE REMEDY
LIGHT S1 DOES NOT COME ON Mains power failure Check electrical mains connection.
WASHING PROGRAM DOES
NOT START
The dishwasher has not yet
finished filling.
Wait for the word FILL to go out.
The word CLOSE remains on
the display
If the word CLOSE remains on the
display even with the door closed,
call the after ‐ sales service.
POOR WASHING RESULTS
Spray arm washing holes
blocked by dirt or limescale
Remove spray arms and clean
them
(10.2 Periodic checks)
Filter fouled
See “Cleaning the filter during the
day”
Too little or unsuitable
detergent or rinse aid
Check type and quantity of
detergent.
No or not enough detergent or
rinse aid being supplied:
detergent or rinse aid not being
taken from the relative
container.
Pipe inside detergent and/or rinse
aid peristaltic pump worn or broke,
have it replaced by the After ‐ Sales
Service.
Plates/glasses badly arranged Arrange plates/glasses correctly.
Low washing temperature
Check temperature shown on the
display, call the after ‐ sales service
if less than 50
Inappropriate cycle set
Increase washing duration,
especially if dishes are very dirty or
dirt has dried on.
Spray arm nozzles fouled ‐ Check that nozzles are clean, and