Smeg CW500, Руководство пользователя

Страница: 14 / 23

13
7 MALFUNCTIONS SHOWN ON THE DISPLAY
The dishwasher is able to identify a number of malfunctions and show them on the display.
If the problem persists after the dishwasher has been switched off and back on, proceed as described below:
Err01
The anti-flooding system has been activated
(for the relevant models only).
Large water leak : check the origin of the problem.
Err04
Tank temperature probe malfunction
Tank temperature probe disconnected or not working
Err05
Tank water filling malfunction
Check dynamic pressure in intake system, inspect water
intake filter and clean if necessary.
If the problem persists:
- tank pressure switch has failed (continuous empty
reading)
- leak from pipe connected to air trap
- valve vent exhaust pipe blocked
Err06
Water pump-out malfunction
Inspect the filters for dirt and that the drain hose is not
blocked, bent or crushed.
Check that the drain pump is not blocked by dirt by
removing the insert on the sump (from inside the tank)
If the problem persists:
‐
with the tank empty: tank pressure switch defect
(the contact is locked on full)
‐
with tank full: drain pump has failed
Err09
Tank water level too high
- with tank full:
see above (water pump-out malfunction)
- with tank empty:
safety pressure defect (the contact
is locked on full)
Err23
Boiler heating malfunction (does not heat
up)
-circuit board relay failure,
- contactor failure.
- boiler safety thermostat failure,
- boiler temperature probe faulty or incorrectly positioned
- water continues to enter the tank due to tank pressure
switch defect
Err24
Boiler temperature probe malfunction boiler temperature probe disconnected or not working
Err25
Boiler water filling malfunction
Check that the water intake tap is on and the dynamic
pressure in the intake system, inspect the water intake
filter and clean if necessary.
If the problem persists:
- boiler pressure switch has failed (continuous empty
reading)
- pipe leaking/disconnected
Err26
Boiler emptying malfunction
- check that rinsing spray arm nozzles are clean
- boiler pressure switch has failed (continuous full reading)
- rinsing pump not working
Err27
Boiler emptying malfunction – with tank full Boiler pressure switch has failed (continuous full reading)
Err28
Boiler heating malfunction (overheating)
-circuit board relay failure, or
- contactor failure