Instructions for the User
109
13.EXTRAORDINARY MAINTENANCE
Occasionally, the oven will require minor servicing procedures or the replacement of parts subject to
wear and tear, such as gaskets, light bulbs, etc. The specific operations for each procedure of this kind
are provided below.
Before carrying out any operation involving access to live parts, disconnect the appliance from the
electricity supply.
13.1 Lubricating the gas oven taps and thermostat
Over time, the gas taps and thermostat of the gas oven may become stiff or jam. Clean their insides and
change their lubricating grease.
This operation must be carried out by a skilled technician.
13.2 Changing the light bulb
Remove the protective cover
A
by unscrewing it anti-clockwise and replace the bulb
B
with another of
the same type (25 W). Replace the protective cover
A
.
Use only light bulbs approved for ovens (T 300°C).
13.3 Removing the door
Fully open the door and turn the hinges
A
to the limit with the aid
of a thin-tip screwdriver.
Take hold of the two sides of the door with both hands close to
the hinges, then partially close it again to an angle of 45° and
remove it.
To reassemble the door, fit the guide
B
back into the oven and
replace the hinges
A
in the position shown here, pressing gently
with a screwdriver or a suitable tool until you hear them snap
into place.
13.4 Removing the gasket
If the oven door gasket requires replacement, contact your nearest authorised service centre.
