SMCSM10-Z Smoke Alarm Guide
Copyright
©
2013 SMC Networks
Page 4
All Rights Reserved
I/M SMCSM10-Z rev. 1.0
6/18/13
F.
Click
Next
. The system scans the premise for
wireless sensors that can be added, which
must meet the following requirements:
-
Not currently paired with another
Touchscreen
-
Is active. New sensors must be activated as
follows; Turn the back cover counter-
clockwise to remove. Open the battery
compartment. Removing the battery
activation tab to power on the unit.
-
Defaulted if previously paired. To default
the sensor, refer to section 9 defaulting
the alarm.
Follow the system prompts to complete the
add process. Trip the sensor by pressing and
holding down the Test Button on the front
cover of the alarm for 10 seconds.
G.
When all the sensors are found and paired,
tap
Done
. Any located sensors that were not
paired are released by the Touchscreen and
can be added later. The Wireless Sensors
Located screen shows the number of wireless
sensors found and paired.
H.
Tap
Next
. The Configure Wireless Sensors
screen shows icons of the sensors that were
found and paired.
I.
Tap
Next
. The Add Sensor/Zone Modify
screen appears.
J.
To modify a field on the Touchscreen, tap
the field. Use the onscreen keyboard to
enter changes. Tap
Next
to save changes.
K.
When all sensors are configured properly, tap
Return to Menu
in the Configure Wireless
Sensors screen.
L.
If all sensors have not been configured, the
Modify screen appears for each sensor to let
you review its details. Change the details as
needed or tap
Next
to cycle through all the
sensors. The sensors are marked as
configured.
7
Mounting the Sensor
The following procedure describes how to mount
the SMCSM10-Z. Add the SMCSM10-Z to the
Touchscreen before physically mounting it in the
desired location.
A.
Test communications between the
Touchscreen and the SMCSM10-Z before
permanently mounting the SMCSM10-Z as
follows:
-
Hold the SMCSM10-Z where you plan to
install it.
-
Press the SMCSM10-Z
Test
button for 10-
to-15 seconds. The SMCSM10-Z sends a
signal to the Touchscreen.
-
At the Touchscreen, verify the signal was
received. A message will appear in the
upper right corner of the Touchscreen for
5 seconds. If no signal is received relocate
the SMCSM10-Z and retest.
B.
Using two supplied screws and anchors,
mount the base.
C.
Attach the SMCSM10-Z to the mounting base
as follows:
-
Line up the raised alignment tab on the lip
of the SMCSM10-Z with the arrow on the
mounting base.
-
Insert the SMCSM10-Z into the base and
turn clockwise about 15 degrees until it
snaps into place.
Note:
The SMCSM10-Z cannot be attached to the
mounting base if no batteries are installed.
