Configuring Your Gateway
80
SMCD3GN-RRR Wireless Cable Modem Gateway User Manual
By default, your Gateway is configured to apply schedule rules to URL blocking 24 hours
every day. To change these settings:
1. To change the days when schedule rules are applied to URL blocking, uncheck
Every Day
under
Week Day
. Then check the days when you want to apply schedule rules to URL
blocking.
2. To change the hours when schedule rules are applied to URL blocking, uncheck
All Day
.
Then specify the start and end times when you want to apply schedule rules to URL
blocking. Select
AM
or
PM
, where AM refers to times from Midnight to Noon and PM refers
to times from Noon to Midnight.
3. Click
Apply
.
C
Coonnffiigguurriinngg EEm
maaiill aanndd SSyysslloogg A
Alleerrttss
The Gateway inspects packets at the application layer, and stores TCP and UDP session
information, including timeouts and number of active sessions. This information Is helpful
when detecting and preventing Denial of Service (DoS) and other network attacks.
If you enabled your Gateway’s firewall or content-filtering feature, you can use the
Email/Syslog Alert menu to configure your Gateway to send email notifications or add
entries to the syslog when:
!
Traffic is blocked
!
Attempts are made to intrude onto the network
!
Local computers try to access block URLs
You can configure your Gateway to generate email notifications or syslog entries
immediately or at a preconfigured time.
To access the Email/Syslog Alert menu, click
Firewall
in the menu bar and then click the
Email/Syslog Alert
submenu in the menu bar. Figure 47 shows an example of the menu.
The menu has three sections:
!
The top area lets you configure your Gateway to send email notifications.
!
The middle area lets you configure the to add syslog entries.
!
The bottom area lets you define the alerting schedule.
Note:
The
Email/Syslog Alert
submenu is not available in the menu bar if
Enable Firewall
Module
is disabled in the Security Settings (Firewall) menu (see page 67).