SMC Networks RS2H Series, Руководство по эксплуатации

Страница: 11 / 25

- 10 -
Caution
(1) Do not apply rotational torque to the cylinder piston rod.
Align the cylinder so that it is parallel to the working face of the pallet in order to prevent rotational
torque acting on the cylinder piston rod.
(2) Do not scratch or gouge the sliding part of the piston rod or guide rod.
Scratches and gouges may damage the seals, causing air leakage or malfunction.
(3) Prevent the seizure of rotating parts.
Prevent the seizure of rotating parts (roller pin, spring pin, etc.) by applying grease.
(4) Do not use until you have verified that the equipment can operate properly.
Verify correct mounting by performing appropriate functional and leak tests with compressed air and
power supplied.
(5) Be very careful when handling the product.
Depending on the handling method, there is a risk that the corners of the product will injure your
hand or fingers, etc.
3-5. How to change the relationship between transfer direction and piping position
The relationship between the transfer direction and piping position can be changed in increments of
90 degrees.
Apply a flat blade screwdriver to the notch in the guide rod end to remove the guide rod. The lever is
released to allow rotations in increments of 90 degrees. When mounting the guide rod, apply thread
locking fluid to the guide rod screw before tightening.
●Guide rod tightening torque
Ø50
,
Ø63, Ø80: 5.2N
･
m
Guide rod
Lever
T
ra
nsf
er
di
rec
ti
o
n
Port
Port Port
Transfer
direction
Transfer
direction
T
ra
nsf
er
di
rec
tio
n
Position of lever: 0°
Position of lever: 90°
Position of lever: 180° Position of lever: 270°
Por
t
Port position
Screw for guide rod
Figure-4