SMC Networks PFMV5 Series, Руководство по эксплуатации

Страница: 7 / 24

-6-
No. PF
※※
-OMK0004-F
●
Product handling

Installation

Tighten to the specified tightening torque.
If the tightening torque is exceeded the mounting screws and brackets may damaged.
If the tightening torque is insufficient, the product may be displaced and the mounting screws may come loose
(Refer to page
14
”Mounting and Installation”.)

Ensure that the FG terminal is connected to ground when using a commercially available switch-mode
power supply.

Do not drop, hit or apply excessive shock to the product.
Otherwise damage to the internal parts can result, causing malfunction.

Do not pull the lead wire forcefully, or lift the product by the lead wire. (Tensile force 49 N or less)
Hold the product body when handling, to prevent damage, failure or malfunction

When connecting the piping, hold the specified part of the body with a spanner.
Hold the product body when handling, to prevent damage, failure or malfunction

Any dust left in the piping should be flushed out by air blow before connecting the piping to the product.
Otherwise it can cause damage or malfunction.

Refer to the flow direction of the fluid indicated on the product label for installation and piping.

Do not mount the body with the bottom facing upwards.
Retention of air can cause inability to measure accurately.

Do not insert metal wires or other foreign matter into the piping port.
This can damage the sensor causing failure or malfunction.

Never mount a product in a location that will be used as a foothold.
The product may be damaged if excessive force is applied by stepping or climbing onto it.

If there is a risk of foreign matter entering the fluid, install and pipe a filter or the mist separator at the
inlet to avoid failure and malfunction.
Refer to the figure below for the recommended pneumatic circuit.
