SMC Networks ISE80(H), Руководство по эксплуатации

Страница: 45 / 61

-44-
PS##-OMM0003-A
Maintenance
How to reset the product for power cut or forcible de-energizing
The setting of the product will remain as that before power cut or de-energizing.
The output condition is also basically recovered to that before power cut or de-energizing, but may change
depending on the operating environment. Therefore, check the safety of whole facility before operating the
product.
If the facility is under accurate control, wait until it has warmed up. (Approximately 10 to 15 minutes)
If the security code is forgotten
The following operation is used only when the security code is forgotten.
<Operation>
Keep pressing the button for 5 seconds or longer in the measurement mode.
The current setting "UnL" or "LoC" is indicated.
Keep pressing
and buttons simultaneously for 5 seconds or longer.
Then, keep pressing and buttons simultaneously for 5 seconds or longer.
∗
: There is no change of the indication.
(At this time, if the other operation is performed or no operation is performed for 30 seconds, the
measurement mode returns.)
After that, keep pressing
and buttons for 5 seconds or longer. The indication changes to "000" and
the security code changing mode returns.
(At this time, if another operation is performed or no operation is performed for 30 seconds, the
measurement mode returns.)
Refer to "How to change the security code" on page 43 and decide the security code.
Changed security code is indicated.
Check and press the
button for 1 second or longer.
The measurement mode returns.
At this time, if the
or button is pressed, changed security code is not entered and the change of
security code is asked.