43
Chapter 7 Troubleshooting
Modem will not dial-out
z
Check your phone cable connected properly into LINE jack.
z
If you use the Tone-dialing on a line, but required the Pulse-dialing method, please
change the command T to P in your dial command line.
Modem will not answer an incoming call
z
Check your phone cable connected properly into LINE jack.
z
By connect a Telephone to the PHONE jack. The attached telephone will ring if you try
calling from another telephone line.
z
Configured the modem to Auto-answer modem.
No connection after modem dial out
z
Remote modem may be not setting to answer mode, if you aren’t hearing a high-pitch
tone when remote modem answering.
z
Perhaps poor-quality or noise telephone lines try another call.
Data error when modem connection
z
Make sure your software data format is match to remote side (for example: 8,N, 1).
z
Make sure the modem flow control method is matched to communication software.
z
Try another call may be poor quality or noise telephone lines.
Fax and voice problems
z
Be sure the Data Communication is installed and worked properly, otherwise check the
mentioned procedure carefully and consult the Fax/Voice manual step by step.
Содержание EZ Modem SMC3056EM
