Unclamping angle display
Seal washer
Head cover
Stopper bolt
135
Lead wire
storage space
Switch on the unclamping side
Base plate
Unclamping angle display
Switch cassette
Protective cover
Switch cassette
mounting bolt
The opposite side
The bolt for opening/closing
This bolt can be mounted to the opposite side.
Metal cover type
Rubber cover type
Metal cover
Washer
Bolt
Top cover
Spacer
Bolt
Setup Procedure
CKZ3T-X2734
x
Switch position change procedure
1) Loosen the switch cassette mounting bolt, and remove the switch cassette.
2) Remove the switch on the unclamping side, and attach in the position of the desired angle. Store the lead wire in the storage space.
3) Mount the switch cassette to the body, and tighten the switch cassette mounting bolt to the tightening torque shown below.
Refer to the replacement parts (page 3) for the part number of the switch cassette replacement part.
1) Mount the top cover to the clamp cylinder, then tighten to the specified tightening torque below.
2) It is possible to change from a rubber cover type to a metal cover type.
Refer to the replacement parts (page 3) for the part number of the top cover replacement part.
z
Stopper bolt position change procedure
1) Remove the stopper bolt of the head cover, and replace with a stopper bolt for the desired angle using the tightening torque below.
When tightening the stopper bolt, hold the head cover.
Refer to the replacement parts (page 3) for the part number of the applicable stopper bolt.
Switch Cassette Mounting Bolt Tightening Torque
Bore size
Tightening torque [N·m]
50
2.6 to 3.5
63
2.6 to 3.5
Stopper Bolt Tightening Torque
Bore size
Tightening torque [N·m]
50
45 to 65
63
85 to 115
Top Cover Mounting Bolt Tightening Torque
Bore size
Tightening torque [N·m]
50
1.5 to 2.0
63
1.5 to 2.0
Arm opening angle change
Top cover replacement
Caution Be sure to confirm safety, and perform the work while the air is exhausted.
Caution Be sure to confirm safety, and perform the work while the air is exhausted.
12
