Technical Information
smb
Trampoline
„π“
Seilspielger•te GmbH Berlin
Page 3
Handwerkerstra‚e 7
15366 Hoppegarten
T49 (0)3342 5083720
T49 (0)3342 5083780
Orientation of the trampoline mat
The reinforcement cross of the trampoline is tagged with a 50 mm long welding bead (see Figure 2). The
direction of this welding bead must run parallel to the lamellas of the trampoline mat.
How to clip the jumping mat:
Tighten the spring
Clip the spring into the eye
Release the spring
Maintenance instructions EN 1176-1
Routine visual inspection
The frequency of this inspection depends on local conditions (high/low usage, vandalism, air
contamination, effects of the weather).
Operational inspection (every 6 months)
Check unit for general damage or wear and tear.
Check condition of the jumping mat, spring suspensions and protective panels.
Main inspection
The trampoline framework consists of galvanised sheets, 2.5 mm thick. Due to this fact, a main
inspection, which then includes checking the framework for corrosion, only needs to be carried out every
two years.
Notice to the type label
The type label is placed in the middle of the side panel. It is fixed there at the inner side. It could be
necessary to remove the jumping mat (
see page 2 and 3, removal/assembly of the jumping mat
), to
read the type label (producer, model, test number, TƒV-seal).
