OPERATION
Removing the SD memory card
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, take out the SD memory card.
17
Inserting the SD memory card
SD Card Error
Occasionally SD cards may fail and may need to be “initialized”. Initializing an
SD card basically clears out the bits of data that may be collected over time,
which may cause recording errors. This is normal and the nature of flash
memory. If there is an SD card failure, the RED LED light will blink on the
remote control*. To resolve the problem, initialize the SD card with the
installation software (see installation software manual). If the initialization is
unsuccessful or there is still a record error, you may need to replace the SD
card.
*The RED LED will also blink in case of camera/video loss. So make sure the
cameras are functioning properly first..
1. Make sure that the power cable is properly connected and turn on the car
power/ignition.
2. Blue LED & Red LED will turn on and slowly blink simultaneously. After
boot is complete, the Blue LED will remain on. Blue LED light means
BX4000 is now ready for the event recording or has started the Normal
recording (Continuous recording).
3. The normal recording (Continuous recording) will be automatically started,
if this is the record mode you have set with the PC viewer software.
4. The Event recording will be started automatically by Motion detection,
Alarm1, Alarm 2, Alarm 3, and/or by the G-sensor level and will begin with
one short “Beep” sound.
5. The Emergency recording can be started by pressing the [PANIC] button.
Turn off the power and then check the BLUE LED light. Once the BLUE LED
light is off, insert the SD memory card.
Always insert memory card when
power is OFF.
