34
To synchronize the control with the motor, the following steps must be followed:
• Disconnect the motor from the power supply and wait more than 10 seconds to plug it back
in. The motor will beep.
• Press the “P2” button on the remote control twice, located on the back next to the battery. A
beep is heard for each press.
• Then press the UP or DOWN button on the remote. Depending on which of the 2 is pressed,
the motor will rotate in one direction or another. 3 beeps will be heard.
• Configuration OK.
This option allows the motor to respond to the command controls continuously if we press once,
or by pressing each time we operate the command.
• Without disconnecting the motor.
• Press the “P2” button on the remote once, located on the back next to the battery. A beep is
heard.
• Press the UP button.
• Press the “P2” button on the remote once again. A beep is heard.
• Configuration OK.
This option allows the motor to be controlled by several controls. Sin desconectar el motor.
• Without disconnecting the motor.
• Press the “P2” button twice on the remote already programmed. Motor beep is heard.
• Then press the “P2” button one time on the remote to add.
• Setting OK.
ADDITIONAL
FUNCTIONS
7.1 CONTROLLER-MOTOR SYNCHRONIZATION
7.2 CHANGE THE CONTROL OPERATION TO MAKE THE PUSHING OR
CONTINUOUS MOVEMENT
7.3 ADD AN ADDITIONAL REMOTE
7.
ENGLISH
