Smartrise KEB-Induction, Руководство для стартапов

Страница: 11 / 20

Drive Startup Manual KEB-Induction
March 5, 2020 ©2020 Smartrise Engineering, Inc. All Rights Reserved Page 3
Wiring
A checklist must be completed during the drive wiring process. See Appendix 1 for terminal
location.
Power
Perform the following to connect power. See C4 Controller sheet 03 Machine Room for job
specific information.
Connect main line power to terminal blocks L1/L2/L3.
Connect the ground wire to the yellow/green terminal block next to L1-L3.
Brake
Perform the following to connect the brakes. See C4 Controller sheet 05 Brakes for job specific
information.
Connect the main brake wiring to terminal K1 / K2 and the secondary brake wiring (if
equipped) to terminals J1 / J2 located on the terminal block next to the M Contactor.
Motor / Encoder
Perform the following to connect the drive to the motor and encoder cable. See C4 Controller
sheet 4 Motor and Drive Connections for job specific information.
Connect motor leads to the M contactor at T1/T2/T3.
Connect the encoder cable to the encoder cable mounted on the drive.
The table below lists the Wiring References for Common Encoders.
Table 1: Wiring References for Common Encoders
Encoder Imperial / PG-X3 Magil IH740 / IH950 Accucoder Wachendorff
Industrial
Encoder
(Canada)
PWR Red (2) Red (2) Brown (2) Brown Brown Brown
COM Black (1) Black (1) White (1) Blue White
(Shield)
White
A White (3) White (3) Green (3) White Green Green
/A Black/White
(6)
Brown (6) Pink (6) Green Red Pink
B Blue (4) Green (4) Yellow (4) Yellow Yellow Yellow
/B Red/Black (7) Blue (7) Blue (7) Gray Black Blue
Z Orange (5) Yellow (5) Gray (5) Gray Gray
/Z Green (8) Orange (8) Red (8) Violet Red
DAT