4
after the decimal point;
These electrical parameters result will be reported to the Z-Wave
™
controller regularly through the
Meter Report of Meter Command Class, the interval of which can be configured by the user by
means shown in "
Configuration: No.11
"
The device also provides the function of reporting the measurement results to the Z-Wave
™
controller when the load current changes and the user can set the changed quantity of the load
current freely by means shown in “Configuration
: No.10
"
The electric quantity detection result is reported to Command Class
Command Class
Command
Scale
Precision
COMMAND_CLASS_METER METER_REPORT
kWh
0.01kWh
Watt
0.01W
Volt
0.01V
Ampere
0.01A
The max cumulative energy is
21474836.47
kWh, if it is over this value, it will be back to 0kWh
automatically.
Reset Cumulative Energy
There have two ways to reset cumulative energy:
1 Z-Wave gateway send METER_RESET command to SmartPlug to reset the cumulative energy
value.
2 Execute the factory reset operation to reset the cumulative energy value.
The cumulative energy will not be reset if SmartPlug remove from Z-Wave Network by exclusion
operation.
Over-current Protection
The outlet can provide a maximum load current of 16A, and when the load current exceeds 16A, the
load power supply will be automatically cut off. And it will inform the host of the overload of the
outlet through NOTIFICATION_REPORT of the Notification Command Class, and meanwhile, the LED
light of the outlet will flash with an interval of one second; Users can remove the overload alarm by
pressing the button or sending SWITCH_BINARY_SET=0xFF, and for safety's sake, before that, users
should remove the load from the outlet first.
Users can control the maximum output current of the outlet by setting the maximum output
current, the setting method of which is shown in "
Configuration: No. 8
".
Overload protection communication Command Class
Command Class
COMMAND_CLASS_NOTIFICATION
Command
NOTIFICATION_REPORT
Type
NOTIFICATION_TYPE_POWER_MANAGEMENT (0x08)
Event
NOTIFICATION_EVENT_POWER_MANAGEMENT_OVERLOAD_DETECTED (0x08)
