3
Association
The device supports 2 association groups, and each group supports max 5 associated nodes.
Group 1
, Lifeline – All nodes which associated in group 1(lifeline group) will receive the messages
that send by device through lifeline.
Group 2
, all nodes which associated in group 2 will be controlled by device through BASIC_SET
command. When device detect a over-current event, the device will trigger a OCP Alarm and send a
notification report to controller, the meantime device also send a BASIC_SET = 0xFF to the nodes
that associated in group 2. And BASIC_SET = 0x00 will be sent after OCP Alarm Event is cleared.
The Command Class supported by each association group is shown in the table below:
Group
Command Class
Command
1 (Lifeline)
COMMAND_CLASS _SWITCH_BINARY
COMMAND_CLASS_NOTIFICATION
COMMAND_CLASS_METER
COMMAND_CLASS_INDICATOR
COMMAND_CLASS_DEVICE_RESET_LOCALLY
SWITCH_BINARY_REPORT
NOTIFICATION_REPORT
METER_REPORT
INDICATOR_REPORT
DEVICE_RESET_LOCALLY_NOTIFICATION
2 (Control)
COMMAND_CLASS_BASIC
BASIC_SET
Device Functionality and Z-Wave™ Message Report
The SmartPlug has four main functions: Switch On/Off, electrical parameters measurement
over-current protection, and timing.
Switch On/Off
There are three ways of controlling the outlet switch:
1) Press the button shortly
2) Operated the device Via Z-Wave
™
Controller or Others Devices that associated it by Command
Class list as below table.
SmartPlug State
Command Class
Command
Value
ON
COMMAND_CLASS_SWITCH_BINARY
SWITCH_BINARY_SET 0xFF
COMMAND_CLASS_BASIC
BASIC_SET
0xFF
OFF
COMMAND_CLASS_SWITCH_BINARY
SWITCH_BINARY_SET 0x00
COMMAND_CLASS_BASIC
BASIC_SET
0x00
Electrical Parameters Measuring
The device provides line voltage (V), loaded current (A), active power (W), and accumulated energy
consumed (kWh) measurement; the significant digits of the measured result should be two digits
