Installation Instructions & Owners’ Manual
SmartSolar™
9
Swing Gate Opener Set Up
SGO-1 Elite™, SGO-4 SecureSwing™ & SGO-4 SecureSwing S™
WARNING:
Do not connect the batteries until
Step A5 is completed.
Step A4 - Mount the Charger Board
Unplug the Control Box from mains power.
Remove the Control Box’s cover, then remove the
transformer, EMC board (if fi tted) and mains power
cable.
Mount the Charger Board on the Control Box’s
base using four brass spacers and four (4) M4x8
screws (Fig. 05).
Plug the Charger Board’s three wire harness (red/
yellow/black) into the DCB-05 board’s “SBY-3”
connector (Fig. 06).
Plug the Charger Board’s one wire harness (white)
into the “24vac in” connector on DCB-05 control
board (Fig. 06).
IMPORTANT WARNING:
Do not connect battery
or solar panel polarity incorrectly - this will result
in serious damage to components.
Step A5 - Connect the Solar Panel
Feed the Solar Panel’s cable through the Control
Box’s grommet
Connect the
red wire
to the Charger Board’s
“
SOLAR+
” connector, and the
black wire
to the
“
–SOLAR
” connector (Fig. 07).
WARNING:
During Step A6 the opener will
become active.
Step A6 - Mount & Connect the Battery
Mount the Battery Box close to the opener.
Feed the 2-core 18awg gauge cable (supplied)
through the Battery Box’s grommet.
Connect the
red wire
to the Battery Box’s “
+
”
terminal, and the
black wire
to the “
–
” terminal
(Fig. 8).
Feed the other end of the battery cable through
the Control Box’s grommet.
Connect the
red wire
to the Charger Board’s
“
BAT+
” connector, and the
black wire
to the “
–
BAT
” connector (Fig. 07).
Step A7 - Re-setup and Test the Opener
Select Menu 7 on the DCB-05 control board, press
“SET”, select Sub Menu 7 (“Battery/Solar”) and
enable using the “OPEN” and CLOSE” buttons.
Setup travel limits and transmitters as per the DCB-
05 instruction manual.
Press either “OPEN” or “CLOSE” buttons, or use a
transmitter to operate the gate.
Refi t the Control Box’s cover.
1.
2.
3.
4.
5.
1.
2.
1.
2.
3.
4.
5.
1.
2.
3.
4.
05
Fig
06
Fig
07
Fig
Re
d W
ire
Black
Wir
e
08
Fig
B
la
ck
F
ro
m
R
e
d
F
ro
m
To
control
Board
