7. Front wheel
Assemble the front wheel quick release axle by
pushing it through the hollow hub, making sure that
one spring is on each side of the hub. Then screw
on the end nut several turns. Next, carefully lift the
bike front forks off the ground and lower the forks
onto the wheel axle, being careful the disc rotor
fits correctly into the disc calipers (this job is best
with 2 people). Tighten the non-rotor side nut finger
tight and try to close the quick release lever. Loosen
or tighten the nut until it takes the correct amount
of force to close the lever. It should be hard to close,
but not so hard you cannot fully close it. It must
fully close (as in picture) otherwise the wheel may
come loose, causing serious injury. Note: if you are
not well trained in cycle assembly, this procedure
must be checked by a cycle technician.
2. Assembly Instructions
3. Main Specifications
FRAME
FORK
HEAD SET
HANDLE BAR
SEAT
SEAT POST
BRAKE
CHAINWHEEL
CHAIN
REAR HUB
FRONT HUB
SPOKES
RIM
TYRE
MUDGUARD
MOTOR
SENSOR
DISPLAY
BATTERY
CONTROLLER
LIGHT SYSTEM
Low step hydro formed top tube with color LCD integrated. L
and M size available
Alloy with suspension
Neco double bearing
31.8x680mm 15 rise
Smartmotion Enduro
Seat post: 31.6x400mm alloy
Tektro hydraulic with Tektro 180mm rotor
Gates 60T 5 bolts for belt drive
Gates CDX 125T belt
Nuvinci N380 CVP 24T
Novatech D341SB double bearing
Black stainless
Alex MD35 with eyelets and wide reflective decals
Schwable 27.5*2.0 Big ben with reflective strip
Full size alloy mudguard
300W (NZ), 250W (Aus), 350W (US) Bafang mid drive with
customized side cover
Torque sensor and Candence sensor
Full color LCD in top tube. 5 levels assist
Panasonic cells 36V 14.5Ah, 36V 11.6Ah option available
Controller: Intelligent sine wave
Front integrated flood strip
Rear integrated LED strip
Front Roxim LED
PanerGT user manual.indd 8-9
7/21/2017 3:21:44 PM
