SmartLabs SML-5112W, Руководство пользователя, Страница: 8 / 14

105318, Russia, Moscow, Shcherbakovskaya str., b. 3. Ph.: (495)645-44-56 page
8
of
14
http://www.smartlabs.tv CONFIDENTIAL
A full table of manufacturers numbers and codes see on http://smartlabs.tv/en/set-
top/codes
6.5 Setting up remote control by using manufacturer's code
1. Turn your TV on.
2. Point the remote control at your TV. Press and hold TV and OK buttons for 3 seconds.
The LED on the remote control will flash twice and the remote control will switch to the
setup mode.
3. Enter the four-digit setup code (see. Table of manufacturers numbers and codes).
The LED will flash each time you enter a digit.
4. If you entered the code correctly, the LED will blink twice. Otherwise
– once.
5. Check the buttons operation. If most of the buttons function correctly, the code is
correct. If necessary buttons do not work properly, select another code from the table
and repeat steps 2 - 5.
If no key is pressed within 20 seconds, or if any non-numeric key is pressed, the remote will
exit the setup mode.
6.6 Controlling volume of STB or TV
Remote can be configured to control the volume of the TV or STB. To switch between
these two states, press and hold for three seconds the buttons <POWER> and V +. The
LED will blink twice and the remote will control the volume of the other device.
6.7 Changing STB code
If using the remote control for STB results in any undesirable interference with your TV
(such as switching TV channels when you switch channels on STB), this means that the
codes used to control STB and TV overlap or are the same.