XX
Step-by-step Instructions
1. Disconnect the power for the existing switches at the circuit breaker or fuse
panel. Verify that the power has been removed by trying to turn on the lights
controlled by the switches.
2. Remove the trim plate from the existing switches.
3. Unscrew and pull the existing switches from the wall box.
4. Disconnect the wires from the existing switches.
5. If the KeypadLinc is being installed into a 3/4/5-way
circuit, the SwitchLinc Multi-way Companion Switch
must be installed in the wall box where power comes
into the circuit. Follow the instructions included with
the Multi-way Companion Switch to identify the "Hot,"
"Neutral," "Ground," and "Traveler" wires.
6. Orient KeypadLinc so the LED is at the top, and make the connections accord-
ing to the "KeypadLinc Wiring Diagram" below.
7. After all connections have been made, ensure that all wire connectors are firm-
ly attached and that there is no exposed copper except for the Ground wire. If
the Yellow traveler wire isn’t used, place a wire cap on it.
8. Gently place the wires and the KeypadLinc into the wall box (with LED at top of
device) and screw into place.
9. Before installing the faceplates, restore power to the circuit. Once power is applied
to the KeypadLinc, the green Status LED will come on after a few seconds.
10. After testing KeypadLinc, install the faceplate (sold separately).
Tip:
For additional help
installing 3-way circuits,
see page 5 in the Multi-
way Companion Switch
manual.
5
1207x-Jun2004web.qxd 6/16/2004 3:28 PM Page 5