HAT162 ATS Controller User Manual Page 13 of 21
8.
PARAMETERS SETTING
8.1
PARAMETERS SETTING MODE
In manual mode, enter into parameters setting mode by pressing
for 8s and manual/auto
indicator and gen status indicator flash;
①
,
②
,
③
,
④
indicators illuminate. LED numbers please
to see the following picture.
Fig.3 Parameter Configuration
NOTE:
At this moment, press
will return to normal mode after LED flash.
8.2
PARAMETERS SETTING
When it entered into parameter setting mode, users can adjusting parameters by pressing
.
And
④
and
⑦
LEDs are illuminated.
①
,
②
,
③
,
④
indicators mean setting items numbers (currently
item number is 1);
⑤
,
⑥
,
⑦
indicators mean these parameter values (currently parameter value is 1).
Configurable parameter list please check “Table 6 Parameters Definition and Range Table (1)” of item
7.
Specific settings are as below:
1)
Select setting number which needs to adjust by pressing
and
;
2)
Enter into setting status by pressing
and
⑦
indicator flashes;
3)
After set this parameter by pressing
and
, and press the key to save the value.
4)
Hold and press
after all parameters are configured, and release
when all LEDs flash,
which means parameters are all saved and then it will return to normal mode.
NOTE:
See “Table 8 Parameter Value Comparison” for the values corresponding of LED indicators.
