PowerForce
–
User Manual
Radlabor GmbH | Heinrich-von-Stephan-Str. 5c | 79100 Freiburg | Germany
www.smartfit.bike | www.radlabor.de
Important warnings
Please read the following warnings, before beginning to use your PowerForce System. Otherwise,
your PowerForce could be damaged, or not function properly.
✓
Do not over tight the pedals in the PowerForce System. Give some grease to the
connective sites to improve the reassembling of the pedals.
✓
If your open a sensor, the transmitter unit or the connection box, the warranty is no
longer valid.
✓
Never clean the sensor or the transmitter unit with water or use it in wet conditions.
✓
Do not cramp the position switch
–
it is sensitive for pressure.
✓
Check before each ride, that the sensors and the pedals are fixed properly.
✓
When unplugging any connection, always pull straight down rather than sideways,
or you could damage connector pins. Never pull on the cable itself, but rather the
plug.
✓
Carefully read through the full installation instructions before beginning, as
mounting the PowerForce System incorrectly can cause a fall or damage the
system.
✓
Do not load the sensor with loads higher than 300kg.