Where the smart things are
®
sm
(949) 429-3303
Technical Support
Smartenit.com
2015 Compacta International, Ltd. - Rev.
8/2015
ZBMLC30
and Smartenit are trademarks of Compacta International, Ltd.
ZigBee is a registered trademark of the ZigBee Alliance
SET Pushbutton Additional Operation
Desired Operation
Action on Pushbutton
Device Behavior
Leave Network
Press and hold for 15~17
seconds (works like a
factory reset, but preserves
meter calibration settings)
Status LED will begin
Fast Flashing
Close Join
Press and hold for 3
seconds when device is in
Open Join
Status LED will stop
flashing
Soft Reset
Tap 10 times
both LEDs will go out
for about a second and
then device will rejoin
network
Request New Firmware
via OTA
Tap 6 times
LED will quick blip off,
once every second
while in OTA progress
Enable for Control4
networks
Press and hold for 10 ~ 12
seconds
Status LED will blink 3
times
Status LED Indication
Pattern
Indication
Fast flashing
Searching for network
Solid
Joined network
Flash once per second
Open Permit Join
Short blip, pause - 5 sec.
Bind to Load1 Out
Fast Flash - 5 sec.
Bind to Load2 Out
2 blips per second
Disconnected from network
Load LED Indication
Color
Indication
Off
No power on load
Red
Load 2 (yellow wire) On
Green
Load 1 (red wire) On
Green/Red Flashing
Load 1 and Load 2 On
(Both loads can only be
turned on via ZigBee)
Open Permit Join
The ZBMLC30 also serves as a router and allows other ZigBee HA devices to join the network. After
the ZBMLC30 has already joined the network (Status LED is solid) proceed as follows:
1. Press and hold the SET button for 6 seconds. The Status LED will blink once per second while in permit
join mode. The ZBMLC30 will allow joining of other devices for up to 4 minutes.
2. Join the new ZigBee HA device to the network according to the join method of that device.
3. Permit-join can be terminated by pressing and holding the SET button for 3 seconds.
Setup
1) Factory Reset ZBMLC30
•
Press SET button on your ZBMLC30 while powering device and release. Alternatively, if the device has already
joined a ZigBee network, press the SET button for at least 20 seconds and release. The Status LED will go out
for 1 second and then begin flashing rapidly. The ZBMLC30 is now searching for an open ZigBee HA network
to join to.
2) Joining the ZBMLC30 to the Network
•
Open a ZigBee HA router or coordinator to permit joining of your ZBMLC30 to the network.
•
As the ZBMLC30 begins to join, the Status LED blinking rate will slow until fully joined, when it’ll be lit solid.
3) Binding the ZBMLC30 to other devices
•
To bind
Load1 Out to a ZigBee HA controller, tap the SET button once quickly and within 1/2 second press and
hold it for 3 seconds. The Status LED will begin to blink (refer pattern in table below). Then press the Program
Button on the client device(such as a switch) according to the instructions of that device.
•
To bind
Load2 Out to a ZigBee HA controller, tap the SET button twice quickly and and within 1/2 second press
hold it for 3 seconds. The Status LED will begin to blink fast (refer to pattern in table below). Then press the
Program Button on the client device(such as a switch) according to the instructions of that device.
•
Binding time window varies by coordinator.
