Longo programmable controller LPC-2.CH1 special module
1. Set the correct RS485 address (S1 switch) for LPC-2.CH1 (refer to the Table 4).
2. Connect interconnection cable to the connector K1. Max. allowed tractive force is 30 N.
3. Put the LPC-2.CH1 in mounting frames
4. Cover LPC-2.CH1 with cover plate
LPC-2.CH1 connects to the MCU unit on its RS485 port using interconnection cable. When more
special modules (e.g. LPC-2.CR1, LPC-2.CH1, LPC-2.DP1) are connected to MCU, splitter is also
required (e.g. SPL-2). Interconnection cable can be terminated on site, considering wiring scheme
bellow:
Figure 5:
Interconnection
cable ICM-x
NOTE
: Signal wires must be installed separately from power and high voltage wires in
accordance with general industry electrical installation standard.
8
