Figure 2
Figure 3
STEP 1 - Top & Side Panel Assembly
In a clean work area lay Top Panel with top facing
down on the floor on cardboard or carpet/packing
quilt. (Fig. 1)
SPX-192426-MDL
Page 4
Lift and place Left Side Panel into 90o vertical position
with fittings facing in. While holding right panel in ver-
tical position, match RV Fittings to one another and
snap panel into place. Use power drill to tighten the
screw contained in the RV Fitting. (Fig.2) Each RV
Fitting contains a screw to lock the hardware once the
panels have been snapped into place. Warranty is
void if all locking screws have not been tightened.
RV Fittings come preinstalled in panels and are
equally spaced along Top edge. Tighten all remaining
RV Fittings along panel edge. (Fig.3)
Repeat STEP 1 for the installation of the Left Side
Panel.
Figure 1
STEP 2 - Back Panel To Sides Assembly
NOTE: 2 person assembly required for proper fit.
Slide Back Panel into position between two Side
Panels matching the cam fittings to the holes at top. It
is necessary for 2 people to accomplish this assembly.
Vertical panels cannot be left standing unsupported
(Fig.4) Insert top 2 Cam Pins through Left and Right
Side Panels into cam fittings. (Fig. 5) Start at the top
cam of each end panel when inserting Cam Pins and
move down each end panel alternating as Cam Pins
are inserted. Make sure arrows on Cam Pins are facing
out (3 pm clock position).
Figure 5
Figure 4
c Smartdesks ltd. 1999
