•
Enter the desired ESSID, Access Point Name,
Channel, and Rates in the respective tabs.
•
If you want to assign a new network settings to airPoint Outdoor, then enter the new IP
address, Subnet Mask, Default Gateway as per your network settings and click on 'Set
configuration', you will get a pop up window with the message "Basic Configuration Set
Successfully".
Restore Factory Default Settings
If you forget the critical settings like WEP or Administrator Password of the airPoint Outdoor, you
can restore the airPoint Outdoor to the Factory Default Settings as,
1. Make sure that the Power to the airPoint Outdoor is ON. ( indicated by PWR LED )
2. Locate and Press the "RESET" button continuously. ( The "RESET" button is located on the
bottom side of the powerShot and you need some pointing device to press the button )
3. The TxRx LED will reduce its light intensity and stop flashing for few seconds.
4. Release the button after the TxRx LED restores back to its original bright intensity and starts
flashing again.
5. After restoring the Factory Default Settings, please configure the airPoint Outdoor again.
Appendix A
Assigning the Temporary IP Address to airPoint Outdoor
1.start the DOS prompt on your Windows PC.
2.Please note down the MAC No. of your airPoint Outdoor( The MAC Address label is pasted
on the bottom of the airPoint Outdoor)
3.MAC No. is a HEX no.(0-9, A-F) so Please make sure when typing that you are not typing
English alphabet "O" instead of numeric "0" (Zero).
4.Please get the Temporary "IP Address" to be assigned to airPoint Outdoor from your LAN
Administrator.
5.Type the following command in the DOS Prompt window:(Replace xx-xx-xx with the actual
MAC No. of your airPoint Outdoor)
6.arp -s 00-30-1A-xx-xx-xx IP Address
7.For more help about arp command type "arp/?" in the DOS Prompt window.
If the Temporary IP Address is set Properly you should be able to Ping the airPoint.Outdoor
1.start the DOS prompt on your Windows PC.
2.Type the following command in the DOS Prompt Window:
3.ping IP Address
4.If you get the ping response without error the Temporary IP is set.
Once the configuration of airPoint Outdoor is over please delete the Temporary IP Address
assigned to airPoint. Outdoor
