TEST PROCEDURE PLT TEST
1. Turn on machine.
2. Keep PLT/HRD switch on “PLT”.
3. Keep SET/RUN switch on “SET”.
4. Set required Test Current (Amperes).
5. Set Cutoff Voltage for test.
6. Set test duration in seconds.
7. Keep SET/RUN switch on RUN mode.
8. Connect Battery Under Test.
9. Machine will show test current,
battery volatge and Test timer.
CURRENT
VOLTAGE
TIMER
CURRENT
VOLTAGE
TIMER
CURRENT
VOLTAGE
TIMER
CURRENT
VOLTAGE
TIMER
CURRENT
VOLTAGE
TIMER
10. Now Press START button or
foot switch (if provided) to start test.
11. machine will put a load of a shown
test current for duration of Test timer.
12. During test machine shows Green
and Red indication alternately.
CURRENT
VOLTAGE
TIMER
CURRENT
VOLTAGE
TIMER
CURRENT
VOLTAGE
TIMER
13. Test will end when timer reaches zero
or battery voltage drops below Cutoff.
14. After completion of test, result is
shown using Green or Red indication.
15.Note down result and press ENTER button.
16. Repeat steps 8 to 15 again for successive battery testing.
CURRENT
VOLTAGE
TIMER
GREEN indication means test is “PASS”
and the battery is GOOD.
Blinking means test is ON.
For changing values use “UP” and “DOWN” keys.
To accept set value and goto next, press “ENTER” key.
NOTE:
Содержание PLT600
Страница 1: ...PRODUCTION LINE TESTER USER MANUAL PLT600...
