13
SET NUMBER OF REPEATS
The Set Number of Repeats command sets the number of times the Greeting message repeats. Valid numbers
of repeats range from 00 to 15. If a user enters a valid number they hear the success beep and return to
command
mode ready to enter the next command. If the entered number is not valid the user hears the error tone and
returns command mode ready to enter the next command.
Syntax... ( X X = any value 00 - 15)
* 1 6 X X # Set Repeats
SET EMPLOYEE PASSWORD
The Set Employee Password command changes the MovieTimeS ring-through Password. The Employee
Password allows the caller to bypass the MovieTimeS and ring-through to a standard telephone connected to the
back of the MovieTimeS. If the Set Employee Password command is entered correctly the user hears the
success beep and returns to command mode ready to enter the next command. To use the ring-through feature
the caller must enter 0 during the Greeting Message then X X X X after the beep where X X X X is the Employee
Password. You must have an optional telephone instrument connected in order to use this feature.
Syntax... ( X X X X = any value 0000 - 9999)
9 4 X X X X # Set Employee Password
SET MASTER PASSWORD
The Set Master Password command changes the units Master Password. Changing the Master Password
prevents unauthorized access to command mode. If you forget or lose your Master Password you will be
unable to seize control of your unit, either remotely or locally, until the unit is refreshed. To refresh the
MovieTimeS machine you must disconnect the power pack plug. Hold the MODE button (on the front
panel) while re-applying power. Continue to hold the MODE button for 5 seconds after applying power to
the unit.
If the Set Master Password command is entered correctly the user hears the success beep and returns to
command mode ready to enter the next command. If the entered password is not valid the user hears the error
tone and returns command mode ready to enter the next command.
Syntax... (X X X X = any value 0000 - 9999)
* 9 2 X X X X # Set Master Password
MEMORY REQUEST
The Memory Request command allows the user to identify how much memory is installed in the system. If the
command is correctly entered the user hears several beeps where each beep represents 1 installed memory
chip, or 2 MB of memory. After the command has completed the unit returns to command mode ready to enter
the next command.
Syntax...
* 8 0 # Memory Request
