12
* 5 0 3 3 # Record Info. Message #1
* 5 0 3 4 # Record Info. Message #2
* 5 0 3 5 # Record Info. Message #3
MESSAGE REVIEW
The Message Review commands allow the user to review each of the messages. After the command is entered
the requested message plays. After message play completes the user hears the success beep and returns to
command mode ready to enter the next command. The user may enter " # " at any point during message
review to abort the play back, at which point the user hears the success beep and returns to command mode
ready to enter the next command. If the selected message has not been recorded the user hears the error tone
and returns to command mode ready to enter the next command.
Syntax:
* 6 0 0 1 #
↓
Review Screen Messages #1 - #24
* 6 0 2 4 #
* 6 0 3 1 # Review Greeting Message
* 6 0 3 2 # Review Movie List Message
* 6 0 3 3 # Review Info. Message #1
* 6 0 3 4 # Review Info. Message #2
* 6 0 3 5 # Review Info. Message #3
MESSAGE DELETE
A current message must be deleted before recording a new message. This will remove any remnants of
the old message, if the new one is shorter.
Each Message Delete command allows the user to delete any one of the messages. While the message is being
deleted the user will hear the system busy signal for a period of time followed by the success beep, returning to
command mode ready to enter the next command. If the user deletes the primary message for the current
Answer Mode, the unit reverts to Bypass Mode after the call is complete.
Syntax:
* 7 0 0 1 #
↓
Delete Screen Messages #1 - #24
* 7 0 2 4 #
* 7 0 3 1 # Delete Greeting Message
* 7 0 3 2 # Delete Movie List Message
* 7 0 3 3 # Delete Info. Message #1
* 7 0 3 4 # Delete Info. Message #2
* 7 0 3 5 # Delete Info. Message #3
SET RING
Set Rings command sets the number of rings that the unit answers on. Valid numbers of rings range from 01 to
15. If a valid number of rings is entered the user hears the success beep and returns to command mode ready to
enter the next command. If the entered number of rings is not valid the user hears the error tone and returns to
command mode ready to enter the next command.
Syntax... ( X = any value 01 - 15)
* 1 1 X X # Set Ring to answer on
