SMART MN610, Руководство пользователя

Страница: 5 / 8

USER’S GUIDE 5
I
NSTALLATION
1. Mount the MN610 in a convenient 3
1/2" rack space using four rack
bolts. Ideally, the monitor should be
located between the processor and the
amplifiers.
2. Using shielded pair wire, connect
the outputs of the processor to the
appropriate inputs on the monitor.
For balanced outputs, tie the positive
(+) terminal of the processor to the
positive (+) terminal on the monitor,
and tie the negative (-) terminal of the
processor to the negative (-) terminal on the monitor. For
unbalanced outputs, use the ground terminal (GND, E) on
the processor to tie to the negative (-) terminal on the
monitor. Tie the shield of the cable to the ground (GND, E)
at the processor, leaving the shield unconnected at the
monitor.
Alternatively, if
the processor
has a THX
Standard output
for monitoring,
connect the
DB25 cable to
the appropriate
jacks on the
processor and
monitor. Do NOT apply signal to both the terminal block
and DB25 connector inputs for the same signal. LEFT
REAR, RIGHT REAR, and any MID or HI frequency terminal
block inputs may be safely used in conjunction with the
DB25 connector.