SMART CX10, Руководство пользователя

Страница: 22 / 112

Basic Operation
22 smart CX10/VX10
4.6 Connecting a Home Network (optional)

In order to connect the receiver to the internet (www) or to a home
network,
• connect the receiver’s LAN socket with a network cable to the ap-
propriate interface of your home network or
• screw the enclosed WLAN antenna on the rear panel and configure
a wireless connection to your home network (only smart VX10).


How to configure a wireless connection or how to ac-
cess the internet or your home network via cable
connection is described in section 7.9.6 on page81.

Plug mains plug into socket, when all devices have been properly con-
nected to the receiver:
4.7 Inserting the Batteries of the RCU
This is the procedure to insert new RCU batteries or to replace empty
batteries:

Open the battery cover at the bottom of the RCU.

Insert two batteries 1.5 V (Type: AAA).
Take care of the right polarity!


Replace batteries when the range of the remote con-
trol is decreasing or when the receiver no longer re-
acts to all commands.

When not used for prolonged periods of time, batter-
ies may leak. Remove batteries from the remote
control if it is not used for long periods of time (> 1.5
years).

When replacing batteries, always replace all batter-
ies.
5 Basic Operation
This chapter describes the necessary steps to use easily the radio and
television programs broadcasted via satellite.