SMARTRG INC. PROPRIETARY AND CONFIDENTIAL. ALL RIGHTS RESERVED. COPYRIGHT © 2016
8
LAN
The four (yellow) RJ45 ports across the back of your gateway labeled LAN1, LAN2, LAN3, LAN4 are the means to connect client devices
such as computers and printers to your gateway.
On some models, one of these four ports may be labeled as WAN indicating SmartPort
TM
support. SmartPort allows a LAN port to be re-
purposed to function as an Ethernet WAN port (described above). When this port is serving as a LAN port, the corresponding LED on the
face of the unit is labeled "WAN"
For instructions to enable this SmartPort
TM
feature, see the
Ethernet Configuration section
in this manual.
USB
USB ports on SmartRG products currently p5 DC volts.
POWER
Use only the power supply included with your gateway. Intended for indoor use only.
External Buttons
Smart RG gateways provide push-button controls on the exterior for critical features. These buttons provide a convenient way to trigger
WPS mode, toggle the WiFi radio on and off, or reset the gateway. Their presence and locations vary by model.
The following describes each of these controls.
WPS Button
The WPS button triggers WPS (Wi-Fi Protected Setup™) mode. WPS is a standard means for creating a secure connection between your
gateway and various wireless client devices. It is designed to simplify the pairing process between devices.
If you have client devices that support WPS, use this button to automatically configure wireless security for your network.
For specific instructions, refer to the Quick Start Guide included with your gateway. Also see the "Basic" section of this manual.
WPS configures one client device at a time. You can repeat the steps as necessary for each additional WPS-compliant device you wish
to connect.
The location of the WPS button varies by model:
l
For SR360n models, the button is located on the top of the unit.
l
For SR510n, SR550n, SR515ac, and SR552n models, the button is located on the left side of the unit.
For other models, an exterior button is not present. However, WPS is supported via the on-board software.
For specific instructions, refer to the Quick Start Guide included with your gateway.
WiFi or WLAN Button
