This appliance shall only be used in above ground open-air situations with natural ventilation,
without stagnant areas, where gas leakage and products of combustion are rapidly dispersed
by wind and natural convection.
Any outdoor enclosure in which the appliance is used shall comply with one of the following:
- An enclosure with walls on all sides, but at least one permanent opening at ground level and
no overhead cover. See Figure 1.
-Within a partial enclosure that includes an overhead cover and no more than two walls.
See Figure 2 & 3.
-Within a partial enclosure that includes an overhead cover and more than two walls, the
following shall apply:
*At least 25% of the total wall area is completely open; and
*At least 30% of the remaining wall area is open and unrestricted. See Figure 4 & 5.
- In the case of balconies, at least 20% of the total of the side, back and front wall areas shall be
and remain open and unrestricted.
The following diagrams provide a diagrammatic representation of outdoor areas. Rectangular
areas have been used in these figures - the same principles apply to any other shaped area.
Figure 1 - Enclosure with walls on all sides but
Figure 2 - Partial Enclosure with overhead cover and no more than 2 walls
Figure 3 - Partial Enclosure with overhead cover and no more than2 walls
Figure 4 - Open side at least 25% of total wall area
30 % or more in total of the remaining wall area is
open and unrestricted.
Figure 5 - Open side at least 25% of total wall area.
30 percent or more in total of the remaining wall area
is open and unrestricted
OUTDOOR USE ONLY
Содержание 401WB-W
