1.6.2 R represents the right point of tire edges. The cursor will show after clicking the
area below the rectangle.
1 6.3 Key in the number of offset you want into the rectangle and complete with ENTER
icon.
.
1 6.4 Press EXIT button to quit the offset page.
.
1.6 Press OFFSET icon to enter the tire width offset adjustment page.
This offset only for solving special issues.
1.7 Press EXIT button to quit the factory setting page.
1.6.1 L represents the left point of tire edges. The cursor will show after clicking the
area below the rectangle.
O
ffset
Y-HOME
OFF SET
L:
0
.
2
0
.
0
mm
mm
R:
1.5.2 Using the four direction arrow to move the right side of cutting bit near to
the alignment block.
1.5.3 Press save button to save the mechanical 0 point. The cutting bit block will be
moving back to home position, after that it will go back to mechanical 0 point.
1.5.4 Press exit button to quit calibration page.
EXIT
The cutting bit block move to Home position
X movement
Y
m
o
v
e
m
e
n
t
Move the cutting bit to the steps of alignment block.
EXIT
Page 3
1.5.1
After entering the calibration page you must click the HOME icon to move the
cutting bit block back to the home position.
HOME
1.5
Click XY-HOME icon to enter the calibration page.
XY-HOME
OFF SET
XY-HOME
OFF SET
EXIT
HOME
X:
mm
0.2
mm
Y: 0.0
