Page 2
1 4.4
Below is the method of changing cutting bit.
.
1 4.4
Enter to the manual mode to move the cutting bit block to center.
.
.1
1 4.4
Use 2.5mm allen key to loosen up the screw. After that put the laser a side.
.
.2
1 4.4
take note that you need to calibrate the truer after changing the cutting bit.
.
.5
Power on the truer. The cutting bit block will back to the home position. Please
X movement
Y
m
o
v
e
m
e
n
t
1 4.4
Power off the main power of the truer before taking out the cutting
bit.
.
.3
1 4.4
Below is a picture to show you the correct direction of the cutting bit. The white
dot for the first cutting bit needs to be at the bottom. The second brass plate needs
to be at between two cutting bit. The white dot for third cutting bit needs to be at
the top. After fixed the all cutting bit, screw up back the laser.
.
.4
1
2
3
