P.4
User Guide
Vehicle
Presets
Heater
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, should not be left on HIGH. It
is recommended to leave the settings on LOW or MEDIUM instead.
Windshield
Wipers,
Radio
&
Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are OFF. Leaving the headlight switch ON on certain
types of vehicles could cause them to remain ON even after remote starter shut down, resulting in
a dead battery.
Using
the
Transmitter
Your remote starter is equipped with a 6-button multi-channel remote control. It can operate two
independent vehicles equipped with identical remote starters (see Multi-car operation section on
page 17).
The functions of the 2-way transmitter are as follows:
LOCK:
Locks the doors and arms the STARTER KILL (if installed).
UNLOCK:
Unlocks the doors and disarms the STARTER KILL (if
installed). Activates the AUX 1 output if Priority Door Access is
configured.
TRUNK:
Opens the TRUNK or activates the AUX 3 output.
Note: Trunk option must be installed.
START:
Remote starts the engine. Gets the system into Cold Weather
mode if pressed for longer than 3 seconds.
Note: Icon may vary.
FUNCTION button
Turns the backlight ON, allows access to the Multi-level
functions and to the Menu.
AUX button (if programmed):
Activates AUX 2 output, stops the engine, requests
Temperature, activates Panic mode or activates Cold Weather
mode.
