-5-
Before Installation
1. Read the instructions carefully.
2. Make sure the door structure is solid and suitable to
be motor driven.
3. Make sure that when the door is moving there are no
friction points.
4. The door must be properly balanced and must be
easily lowered and raised by hand.
5. A 240V, adequately protected 3-pin power outlet must
be near where the Smart Roller Nano opener is going
to be installed.
Remember
there are specific standards that have to
be strictly followed regarding the safety of electrical
installations for automatic gates and doors.
As well as the legal requirements and standards that
must be adhered to, please take note of the following
points to ensure maximum safety and reliability of your
installation.
6. Prior to installing check the surrounding environment.
Carefully evaluate any hazards there could be from
physical damage (transiting vehicles, parts of trees
falling etc.), possible contact with foreign bodies
(insects, leaves, etc.), flooding hazards or any others
exceptional events.
7. Check that the main voltage is the same as that given
on the rating plate and in this manual.
8. Check there is suitable electrical protection against
short circuits/power spikes and proper earthing on the
mains supply.
Remember
the unit has mains voltage running through it
(electrocution hazard, fire hazard).
9. Take care with the opener; parts may be subject to
damage if abused.
10. Make sure you have all the necessary installation
materials and that they are suitable for this kind of use.
11. Read all the instructions thoroughly and make sure
they are understood before attempting to install the
Smart Roller Nano.
12. Before starting the installation, carefully analyse all the
risks relating to automating the door. Verify that the
door to be automated is in a sound condition and that
the mechanisms are in good working order; observe
the safety margins and minimum clearances.
13. Evaluate with particular care the safety devices to be
installed and where to install them; always install an
emergency stop device for interruption of power to the
opener if required.
14. Once the risks have been analysed, install the Smart
Roller Nano opener and relative safety devices,
emergency stop and/or photo electric cells.
Important:
For additional safety Smart Openers Pty Ltd
strongly recommends the fitting of photo electric safety
beams on all installations.
15. When installing the Smart Roller Nano opener, strictly
follow all the instructions given in the instruction
manual. If some points or procedures in this manual
are not very clear do not install the unit until all doubts
have been cleared up with our technical department.
IMPORTANT NOTICE
This opener is not designed to accept extension fingers
to engage recessed curtain drum wheel spokes as has
been done in competitor’s openers for the past ten years
or so. The forks in the Smart Roller Nano opener are not
designed to accept any such extension fingers and the
fitting of extension fingers is not necessary. The lengths
of the forks of this opener are slightly longer than those
used in competitors openers in any event.
© February 2009 Smart Openers Pty Ltd
