Smart Openers SMART ROLLER DUO, Руководство по установке

Страница: 6 / 16

-6-
Before Installation
1). Read the instructions carefully.
2) Make sure the door structure is solid and suitable to
be motor driven.
3) Make sure that when the door is moving there are no
friction points.
4) The door must be properly balanced and must be
easily lowered and raised by hand.
5) A 240V, adequately protected 3-pin socket must be
near where the Smart Roller Duo opener is going to
be installed.
Remember there are specific standards that have to
be strictly followed regarding the safety of electrical
installations and automatic gates and doors.
As well as the legal requirements and standards that
must be adhered to, please take note of the following
points to ensure maximum safety and reliability of your
installation.
6) Prior to installing check the surrounding environment.
Carefully evaluate any hazards there could be from
physical damage (transiting vehicles, parts of trees
falling etc.), possible contact with foreign bodies
(insects, leaves, etc.), flooding hazards or any others
exceptional events.
7) Check that the main voltage is the same as that given
on the rating plate and in this manual.
8) Check there is suitable electrical protection against
short circuits/power spikes and proper earthing on the
main supply.
Remember the unit has mains voltage running through it
(electrocution hazard, fire hazard).
9) Take care with the control unit; parts may be subject
to damage if abused.
10) Make sure you have all the necessary materials and
that they are suitable for this kind of use.
11) Read all the instructions thoroughly and make sure
they are understood before attempting to install the
Smart Roller Duo.
12) Before starting the installation, carefully analyse all
the risks relating to automating the door. Verify that
the door to be automated is in a sound condition
and that the mechanisms are in good working order;
observe the safety margins and minimum distances.
13) Evaluate with particular care the safety devices to be
installed and where to install them; always install an
emergency stop device for interruption of power to the
opener if required.
14) Once the risks have been analysed, install the Smart
Roller Duo opener and relative safety devices,
emergency stop and/or photoelectric cells.
Important: For additional safety Smart Openers Pty Ltd
strongly recommends the fitting of Photo Electric safety
beams on all installations.
15) When installing the Smart Roller Duo opener, strictly
follow all the instructions given in the instruction
manual. If some points or procedures in this manual
are not very clear do not install the unit until all doubts
have been cleared up with our technical department.
Important: Make sure that the motor wires have been
connected to the wiring harness correctly.
They should be:
Red – Red
Green – Yellow
If this is not the case please swap the connection to the
above polarity before proceeding.
Red
Red Green
Yellow