SMART Embedded Computing RTM-ATCA-747x-10G Series, Инструкция по установке и эксплуатации

Страница: 34 / 60

34 RTM-ATCA-747x-10G Installation and Use (6806800S80F)
Hardware Preparation and Installation
Hardware Preparation and Installation
6. Insert the hard disk module into the slot until it is fully inserted.
7. Tighten the two thumb screws of the hard disk module.
8. Take all necessary steps in your operating system to make the hard disk operable (the
step depend on the OS you are using).
2.5 Installing and Removing the RTM
The RTM must be installed into a ATCA system without a Zone 3 midplane.
The RTM provides support for basic hot swap, that means it can be installed,
removed and replaced in a powered system. However, after the RTM is installed or
replaced in a powered system the front blade has to be rebooted so that the OS
can recognize the SAS controller or other PCI devices located on the RTM.
NOTICE
RTM Damage
Installing the RTM with other blades than those listed in the table below may
damage the RTM and the front blade.
Only install the RTM with the SMART EC blades listed in the table below.
Damage of Circuits
Electrostatic discharge and incorrect RTM installation and removal can damage
circuits or shorten their life.
Before touching the RTM or electronic components, make sure that you are working
in an ESD-safe environment.