2. Setting the cable length dials
The Receiver unit is preset for approximately 50m which is sufficiently accurate for most
applications. However if the image does not look sharp enough then follow the instructions
below
2.1
Whilst looking at an image on the display, preferably a long horizontal
bar, adjust the CABLE COMPENSATION dial.
2.2
Looking at the right-hand edge of the bar you will see the image
change. A highlighting bright edge means over compensation, whilst
a blurred dark edge means under compensation.
2.3
Adjust the dial until both effect are neutralized.
The Contrast control dial is factory pre-set and usually needs no adjustment.
-
12-
Installation and Operation—SLX-RX100
