STEP 1 – CONNECTING THE SDS-RX1000 FRONT PANEL
1.
First connect the video signals to the display device – RGBHV, HDMI and Composite Video (CV).
2.
Next the audio, the 2 x audio outputs are the same signal from the wall plate transmitter however,
there will be separate inputs for the RGBHV and composite video so connect accordingly.
3.
The RS232 connection is optional but allows for automatic input selection of the display when
each signal type is chosen, if needed the standard cable is a 3,5mm mini-jack plug to D9 plug
(Smart-e partcode CAB-JDM-1M).
The SDS-RX1000 can be programmed with the appropriate RS232 string associated with each signal
type – this is achieved by connecting to the wall plate RS232 port and running the programming
application.
SDS-1002/3 SETUP GUIDE – SDS-RX1000 FRONT
INTRODUCTION
The SDS-RX1000 is a universal receiver for all the SDS-TX1000 series wall plate transmitters. The 3 x
CAT cable connection allows simultaneous transmission of RGBHV, HDMI, RS232, a single audio channel
and remote power. The composite video and USB channel is shared on the cable therefore the SDS-
RX1000 has different modes depending on which wall plate is fitted.
When correctly connected to a wall plate the SDS-RX1000 receives communication identifying the type of
wall plate attached. Once this communication has occurred the appropriate LED on the SDS-RX1000 is lit
to show the ‘active’ state. On powerup all 3 LEDs may flash for a few seconds whilst communication is
established.
CV
RGBHV
HDMI
RS232
AUDIO
x2
SDS-1002 & 1003 SETUP GUIDE
Copyright 2012 Smart-e Ltd
Page 2
