SMART Board 800ixe-MP, Конфигурация и руководство пользователя, Страница: 54 / 102

6. Use the handle on the bottom of the lamp module to slide out the lamp and remove it from the
projector.
g
To put the new lamp module into the projector
1. Remove the new lamp module from its packaging.
2. Carefully place the lamp module into the projector using the handle on the top of the module.
Hold the lamp module vertically and guide it into its slot. Gently press the power end of the
lamp module against the projector to ensure the power plug makes contact with the projector’s
power receptacle.
3. Use the Phillips screwdriver to tighten the captive screws.
4. Carefully slide the lamp cover back onto the projector.
5. Connect the power cable to the wall outlet.
6. Press the Power button once on the remote control or ACP to confirm that the projector is
operating and that the lamp module is correctly installed.
7. Put the old lamp in a secure container, and handle it gently until you recycle it.
g
To finish the projector lamp installation
1. Turn on the projector.
2. Access the service menu to reset the lamp hour counter (see Resetting the lamp timer on the
next page).
3. Activate the projector’s alert e-mails and lamp warnings if they’ve been deactivated (see E-mail
alerts on page 69 and Control panel on page 66).
C H A P T E R 6
Maintaining your interactive whiteboard system
44