EN
EN
7
8
2. Press, one beep is heard a
[9]
nd the LED indicator is on. Keypad
enters learning state.
3. Put RFID tag close to the RFID reader, the connection succeeds after
one beep and the LED indicator goes out.
If two beeps are heard, it indicates the RFID tag has been connected
before.
To clear the connection of RFID tags, input
[admin code]
+
[#]
to
wake up the keypad and then press down
[9]
for six seconds. RFID
tags are all cleared after one beep..
Connect Electric Door Lock
To know connection steps, please refer to the instruction manual of
electric door lock.
Installation
Fix the keypad on the wall before use.
①
Loose the screw, open the case
②
Fix the rear cover on the wall by screws
③
Fasten the front cover of keypad on the rear cover. Secure two
covers into place and then screw on
Note:
Opening the rear cover of keypad will trigger tamper switch, please
disarm the alarm by following the disarm instruction in page 21-22.
