Warranty/Parts/Service
For home usage, products are warranted for one year from date
of purchase against manufacturer or workmanship defects.
Commercial users have a 90 day warranty.
Your authorized dealer is the best source of replacement parts
and service. To obtain prompt, efficient service, always
remember to give the following information...
- Correct Part Description and/or part number.
- Model number/Serial number of your sprayer.
Part descriptions and part numbers can be obtained from the
illustrated parts list section(s) of this manual.
Whenever you need parts or repair service, contact your
distributor/dealer first. For warranty work, always take your
original sales slip, or other evidence of purchase date, to your
distributor/dealer.
40 Gal. Corrosion-Resistant Polyethylene Tank
•
12 Volt Diaphragm Pump, 2.1 g.p.m. - 60 p.s.i.
•
Deluxe Pistol-Grip Handgun w/25 Ft. Handgun Hose
•
25 Ft. max. vertical throw, 35 Ft. max. horizontal throw
•
Low Profile Trailer & Tank
•
15/600 x 6 (2-Ply) Pneumatic Tires
•
Pressure Gauge
•
Adjustable Pressure
•
5-Nozzle Boom Assembly, 100" Spray Coverage
•
Breakaway Outer Boom Members
•
Technical Specifications
Form No. 1561 [5004972 (04/14)] Printed in the U.S.A.
Model: 800-TRL40ST (5301789)
(40 Gallon Lawn & Garden Trailer Sprayer w/5-Nozzle Boom
Owner's Manual
General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn &
garden trailer sprayer. Please read it carefully, as it furnishes
information which will help you achieve years of trouble-free
operation.
Your sprayer has been partially assembled at the factory. Follow
the instructions below to complete the assembly of this unit. (Refer
to the exploded view drawing later in this manual)
1. Mount the axle to the frame, securing it with the hardware
provided.
2. Slide a wheel spacer and a wheel (valve stem out) onto each
end of the axle, then use a cotter pin to secure the wheels in place.
3. Bolt the boom brackets to the back of the frame. (if not already
done)
4. Bolt the boom assembly to the boom brackets. The tips need to
be approximately 18"-22" above the spraying surface. Secure in
place with (2) square u-bolts and whiz nuts provided. The outer
boom members need to fold rearward.
5. Thread the pressure gauge into the elbow of the manifold. Use a
good grade of sealant, to insure no leaks.
6. Remove the drain plug, handgun clips, and attach them to the
tank, as shown.
7. Attach the 'loose' boom feeder hose to the hose barb on the
boom line on the manifold and to the poly feeder "cross" fitting on
the boom. (the center nozzle) Secure in place with 1/2" hose
clamps.
8. Connect the electrical hook-up to the end of your pump and clip
the clips to a fully charged battery. The red wire must be
connected to the positive (+), and the black wire should be
connected to the negative (-).
Assembly Instructions
2415 Industrial Dr. - Jonesboro, AR 72401
Phone: 870-935-3291 - Fax: 870-935-5651
