5
User's Manual PS112A / PS115A
6
Precautions
Please read carefully before proceeding
Warning:
Always follow the basic precautions listed below to avoid the possibility of serious injury or even
death from electrical shock, short-circuiting, damages, fire or other hazards. These precautions
include, but are not limited to, the following:
Power supply / power cord (devices with power cords/power supplies
)
:
• Only use the voltage specified as correct for the device. The required voltage is printed on the
type plate of the device. Check the power cable from time to time regarding dirt, damage or other
influence.
• Use only the included power cord / power supply or adaptor. Do not place the power chord near
heat sources such as heaters or radiators, and do not excessively bend or otherwise damage the
cord, place heavy objects on it, or place it in a position where anyone could walk on, trip over, or roll
anything over it.
• Remove the electric plug from the outlet when the device is not to be used for extended periods of
time, or during electrical storms. When removing the electric plug from the device or an outlet,
always hold the plug itself and not the cord. Pulling by the cord can damage it.
• To avoid generating unwanted noise, make sure there is adequate distance (50 cm or more)
between the AC power adaptor and the device. Do not cover or wrap the AC power adaptor with a
cloth or blanket.
Batteries / safety instructions (devices with batteries
)
:
• Use only high quality batteries – do not mix batteries with rechargeable accumulators.
• Do not try to recharge non-rechargeable batteries.
• Keep attention to the polarity when changing the batteries (polarity is signed on the device).
• Do not cause an electrical short at the batteries, do not open the batteries.
• Changing of batteries must not be done by children, do not let children play with batteries.
• Remove batteries from the device when the Device is not in use for a longer period.
• Batteries are special waste, do not dispose them with the domestic waste.
Location:
• When setting up the device, make sure that the AC outlet you are using is easily accessible. If
some trouble or malfunction occurs, immediately turn off the power switch and disconnect the plug
from the outlet.
When you are not using the product for a long time, make sure to unplug the power cord from the
wall AC outlet.
• Inadequate ventilation can result in overheating, possibly causing damage to the device(s), or
even fire.
• Do not expose the device to excessive dust or vibrations, or extreme cold or heat (such as in
direct sunlight, near a heater, or in a car during the day) to prevent the possibility of panel
disfiguration or damage to the internal components.
• Do not place the device in an unstable position where it might accidentally fall over.
• Do not block the vents. This device has ventilation holes at the bottom/rear to prevent the internal
temperature
from becoming too high. In particular, do not place the device on its side or upside down.
• Do not use the device in the vicinity of a TV, radio, stereo equipment, mobile phone, or other
electric devices. Doing so may result in noise, both in the device itself and in the TV or radio next to
it.
XLR AUDIO OUTPUTS
LINE IN
LIN
E
IN
LIN
E
IN
LINE IN
LINE OUT
LINE OUT
Esempio 3
Esempio 1 / Esempio 2
I
T
A
L
I
A
N
O
E
N
G
L
I
S
H
MIC IN
RCA IN