SLS themo, Инструкция по установке и эксплуатации

Страница: 14 / 20

5. Reconnect wires.
Connect the Themo thermostat according to the
connection diagram.
•
Tip: If you are replacing an existing thermostat, use the
stickers as a guide when inserting the wires into the
Themo terminal blocks.
The wires from the wall should plug easily into the terminal
blocks. Use a screwdriver to tighten the terminal screws.
Fasten the thermostat firmly to a flush mounted wall box or
an exterior wall box by driving the screws through the holes
in each side of the thermostat.
14
Note: The screen of the heat-
ing cable must be connected
to the earth conductor of the
power supply cable using a
separate connector (capped
with wire nuts).