6
STEP 7.
Installing/replacing batteries for sensor
models (Fig. 14)
1. Open the cover. Remove the pouch
holder.
2. Place the key into the battery box hole
to remove the battery box cover.
3. Install four new C-cell batteries in
/- orientation.
NOTE: Supplied batteries are intended for
checking operational status only. Install new
batteries before operating. If the unit will be
dormant for some time, remove batteries
and store properly. Immediately remove
batteries and replace when the red LED
flashes.
Cover
Keyhole
Cover
Key
STEP 8.
Installing/replacing Soap/Sanitizer
pouches for manual units (Fig. 15)
1. Open the cover and remove the pouch
from the dispenser.
2. Place the new pouch in the holder.
3. Remove the cap from the pump.
4. Close the cover.
Installing/replacing Soap Pouches for
Sensor Units (Fig. 16)
1. Open the cover and remove the pouch
from the dispenser.
2. Place the new pouch in the holder.
3. Set the pouch pump in the battery box.
4. Remove the cap from the pouch pump.
5. Close the cover.
Fig. 13
Fig. 14
STEP 6.
Opening/closing the cover (Fig. 13)
Place the key into the keyhole on the top
of the dispenser. Holding the cover, open
it toward you.
Return the cover to its original position
and press it until it snaps into place.
