3
Soap Refill Bottle Installation and Removal
Refill Installation
(refill sold separately)
9
Feed the dispense tube A on the
Refill Bottle 9 up through the
Motor Assembly/Bottle Support 7
and Dispenser Assembly 1 ,
aligning the two indents in the
Bottle and the Support. Slide the
Bottle upward until it snaps into
place.
NOTE:
The refill is not properly
installed until you hear the “snap”
(as the Green release latch on the
Motor Assembly/Bottle Support 7
engages).
Test the
System by
passing your
hand under
the spout of
the Dispenser
Assembly 1
(in front of the sensor window) at
least three or four times, until
foam soap appears. If the System
does not dispense soap after
passing your hand in front of the
sensor several times, repeat sev-
eral more times. If no sound heard
from motor assembly after placing
hands in front of sensor, check to
see that the Data Cable 6 halves
are firmly connected, that the
batteries are “good”, and that the
Battery Box 8 cover is properly
positioned and fastened to the
Box. Check for bent contact pins
inside connector 6b . If unit is
multi-activating, check for bent
contact pins inside connector 6b.
Refill Removal
Grasp the empty Refill Bottle 9
with one hand and use the other
hand to push the Green release
latch on the Motor
Assembly/Bottle Support 7 to
the right (counterclockwise as
seen from above).
Grasp the empty Refill Bottle 9
with one hand and use the other
hand to push the Green release
latch on the Motor
Assembly/Bottle Support 7 to
the right (counterclockwise as
seen from above).
Soap Replacement
To order replacement soap cartridges:
CONTACT
GOJO
Industries at 800.321.9647
Available refills
ESD-321 8565-02-N6300GN: 1500 ml Green Certified Foam Refill (2 Pack)
ESD-322 8545-04-N6300GN: 2300 ml Green Certified Foam Refill (4 Pack)
ATTENTION:
do not handle by tube. For proper operation, ensure that tubing is
not loose or bent.
Cleaning the Counter Mounted System
Use only mild soap and water to clean the Touchfree Counter Mounted
System spout. Cover the sensor window with your thumb while cleaning the
spout so that you do not continue to dispense soap.
DO NOT
use abrasives to clean the TouchFree Counter-Mounted System
(as this may damage the finish or the sensor window).